cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
682
Views
0
Helpful
8
Replies

vdc nexus 7000

Rodrigo Bezerra
Beginner
Beginner

created the vdc, allocate interfaces, but when I do a show running in vdc interfaces not appear.

could help me?? thank you.

8 Replies 8

Reza Sharifi
Hall of Fame Expert Hall of Fame Expert
Hall of Fame Expert

When you are in admin VDC, when you do a "sh run" do you see the interfaces being allocated the vpc you created?

what is the output of sh run in admin vdc?

What type of modules you have in the chassis?

HTH

I am using the Module N7K-F248XP-25 and when I do the show running, only see the interfaces allocate the vdc_1. But allocation interfaces for vcd_2 and does not appear, reload in need Make nexus7k to appear in the interfaces that allocation vdc_2?

Thank you.

No, there is no need for reload.  What type of module is allocated to vdc_1?

Also have a look at this link.  You may not be grouping the ports together correctly.

On the Cisco Nexus 7000 Series 48-port, 10-Gbps  Ethernet module N7K-F248XP-25[E], you must allocate the interfaces on  your physical device in the specified combination. This module has 12  port groups that consist of 4 ports each (4 interfaces x 12 port groups =  48 interfaces). Interfaces belonging to the same port group must belong  to the same VDC

http://www.cisco.com/en/US/docs/switches/datacenter/sw/nx-os/virtual_device_context/configuration/guide/vdc_mgmt.html

HTH