VDC question

[XIE YAO]

Hi team,

New to NXOS, not sure if this is the right place to post.

Just want to know if I run a show-tech in one VDC, will it include information for other VDC as well?

Thanks.

[Bilal Nawaz]

I can't remember since its been a while when i ran show tech on a N7K, but from what I recall, if you do show tech from the default VDC, it should capture for all other vdc's. Not sure if there was an option to choose a vdc by its name after the command like "show tech vdc" I dont think it was the case.
 

[XIE YAO]

when you say default vdc, are you referring to the vdc id 1? or admin vdc?

[Bilal Nawaz · Accepted solution]

The admin vdc which is usually vdc id 1 anyway.

Default and admin VDC cannot coexist at the same time. VDC 1 can either configure as default or Admin.

[InayathUlla Sharieff · Accepted solution]

To get this info:-

Show tech vdc-all -( run this from default vdc and it will captured all vdc info)

Regards

Inayath