03-13-2024 10:10 AM
Hello all,
I hope all is well.
I just had a small question about how to verify that root guard has been enabled on a interface after running the command:
Switch#(config-if)#spanning-tree guard root
I have tried a few show commands and I have tried looking through cisco docs but I cannot find anything.
Thank you
Solved! Go to Solution.
03-13-2024 11:42 AM
Hi,
Try
sh spanning-tre interface tenGigabitEthernet x/y/z detail
sh spanning-tre interface GigabitEthernet x/y/z detail
HTH
03-13-2024 11:42 AM
Hi,
Try
sh spanning-tre interface tenGigabitEthernet x/y/z detail
sh spanning-tre interface GigabitEthernet x/y/z detail
HTH
03-13-2024 12:38 PM
@Reza Sharifi correct
04-01-2024 11:00 AM
Thank you and sorry for the late reply.
04-01-2024 11:00 AM
Thank you so much and sorry for the late reply.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide