cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1180
Views
0
Helpful
3
Replies
Highlighted
Beginner

VFC is Down (Error disabled): Nexus B22 FEX for Dell to Nexus 5596UP

Dear Experts,

I'm trying to get the VFC up in B22-FEX blade in Dell whic is connecting to Nexus 5596UP.

Could you take a look at this and help please.

Attaching the config of 5596UP

The message I get is

# sh int vfc1033

vfc1033 is down (Error Disabled - VLAN L2 down on Eth interface)

    Bound interface is port-channel3

    Hardware is Ethernet

    Port WWN is 24:08:00:2a:6a:0d:db:3f

    Admin port mode is F, trunk mode is on

    snmp link state traps are enabled

    Port vsan is 2

    1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec

    1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec

      0 frames input, 0 bytes

        0 discards, 0 errors

      0 frames output, 0 bytes

        0 discards, 0 errors

    last clearing of "show interface" counters Wed Mar  4 10:27:35 2009

!

Ethernet1/3 is up

Dedicated Interface

  Belongs to Po3

!

port-channel3 is up

  Hardware: Port-Channel, address: 002a.6a0d.db0a (bia 002a.6a0d.db0a)

  Description: SIT_DellB22_C1

  MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec

  reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA

  Port mode is fex-fabric

3 REPLIES 3
Beginner

VFC is Down (Error disabled): Nexus B22 FEX for Dell to Nexus 55

Additional information below.

When port-channel 3 is set to switchport mode fex-fabric  the VFC changes to error disabled, but FcOE channels (1-15) changes to UP

When port-channel 3 is set to switchport mode trunk, the VFC changes to UP, but FCoE channels changes to down.

Hall of Fame Community Legend

VFC is Down (Error disabled): Nexus B22 FEX for Dell to Nexus 55

Duplicate post.

Beginner

VFC is Down (Error disabled): Nexus B22 FEX for Dell to Nexus 55

Both VFCs and FCOEs are up now.

(There was an issu in binding to interfaces.)

Still not reading the WWNs and MACs from B22/Qlogic/DellM1000e

LACP is enabled.

Vlan 1 is native

Please let me know of any info on how to read WWN and MAC details.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards