Dear Experts,
I'm trying to get the VFC up in B22-FEX blade in Dell whic is connecting to Nexus 5596UP.
Could you take a look at this and help please.
Attaching the config of 5596UP
The message I get is
# sh int vfc1033
vfc1033 is down (Error Disabled - VLAN L2 down on Eth interface)
Bound interface is port-channel3
Hardware is Ethernet
Port WWN is 24:08:00:2a:6a:0d:db:3f
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port vsan is 2
1 minute input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 minute output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 discards, 0 errors
0 frames output, 0 bytes
0 discards, 0 errors
last clearing of "show interface" counters Wed Mar 4 10:27:35 2009
!
Ethernet1/3 is up
Dedicated Interface
Belongs to Po3
!
port-channel3 is up
Hardware: Port-Channel, address: 002a.6a0d.db0a (bia 002a.6a0d.db0a)
Description: SIT_DellB22_C1
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
Port mode is fex-fabric
