VLAN Tags Cisco 2811 Layer2 connection

[jamiebenger]

Hi, very new to vlans and need a little advice.

We have 2 cisco 2811 routers. And 2sites linked by Layer 2 connection with overture isg180's at ether end.

The problem we have is that we have been supplied with very limited information from the installation company.

All we have been told is

VLAN to Sheffield = 2021

VLAN to Birm = 2020

I believe these to be the Vlan tags?

Does anyone have a sample of a config files i look at or point me in the right direction?

Any help would be appreciated

Thank you in advanced

[srue]

not sure if this is what you're looking for, but here's an example:

interface FastEthernet 1/0.4

encapsulation dot1q 4

The subinterface 1/0.4 is enapsulated using dot1q and is assigned to vlan 4

[jamiebenger]

Hi thanks for your reply.

i have tried that, but still no joy.

how do i assign the vlan tags of 2020 to the vlan 4?

[jamiebenger]

Sorted now. turns out the supplier of the national ethernet lines had given me the wrong Vlan Tags.

All i needed to do was set nottingham up as

SUB-IF encapsulation dot1q (VLAN TAG)

IP Address

No Shutdown

And all works now

Thanks