cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1479
Views
0
Helpful
2
Replies

Vlan Trunk Between Dell PowerConnect 5324 and Cisco Cisco 2811 (Intervlan-routing)

sistemastel
Level 1
Level 1

Hi Everybody:

 

Im conecting a phisical trunk, between  switch Dell PowerConnect 5324 and Cisco 2811 Router, please see the attachment topology, I can't not ping between the PC A and PC B, I will show the configs:

The config in the router CISCO:

!
interface FastEthernet0/0 
 description Cisco to Trunk DELL
 no ip address
 duplex auto
 speed auto
!
!
interface FastEthernet0/0.2
 description VLAN 2
 encapsulation dot1Q 2 native
 ip address 200.71.155.193 255.255.255.248
!
interface FastEthernet0/0.3
 description VLAN 3
 encapsulation dot1Q 3
 ip address 201.249.204.153 255.255.255.248
!

 

Config DELL POWERCONNECT:

Configuring VLAN Trunk in Ethernet G23 :

interface ethernet g23
switchport mode trunk
switchport trunk allowed vlan add 2,3
exit

 

ADDING VLAN 2 AND 3:

enable
configure
vlan database
vlan 2
vlan 3
exit

 

Configuring Ports  E2 , E3 in VLANS 2, 3 respectivily:

interface ethernet e2
switchport mode access
switchport access vlan 2
exit

interface ethernet e3
switchport mode access
switchport access vlan 3
exit


copy running-config startup-config

 

Could you tell me what is missing on my config? Thanks in advance.

2 Replies 2

Jon Marshall
Hall of Fame
Hall of Fame

I'm not familiar with that make of switch but have you made vlan 2 the native ie. untagged vlan on the switch ?

If not then it may be easier on the 2811 to simply change -

int fa0/0.2

encapsulation dot1q 2 native

to

int fa0/0.2

encapsulation dot1q 2

ie. remove the native keyword and retry.

Jon

Thanks you, I am going to do that, it is true, because I dont configure native VLAN on DELL switch, may be this is the problems cause.  

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: