I have three VLAN's configured in a C3560 Software (C3560-IPBASEK9-M), data, voice and WAN.
The WAN VLAN has two routers connected, I need to know how I can send voice traffic by one router and data traffic by another router, do you know how I can do it?.
Can I do it with this IOS?.
If you are running IP Services on your 3560 then it already supports PBR. You will however need to enable the SDM routing template ie.
3560(config)# sdm routing prefer
No, I have: Image Name c3560-ipbasek9-mz.122-40.SE.bin.
But I got: c3560-ipservicesk9-mz.122-40.SE.bin
So I need to know how to upgrade it ?.
Use this link to upgrade to IPServices -
Thank you by your support.
The procedure shows the next command:
archive download-sw /allow-feature-upgrade /overwrite /reload tftp:[[//location]/directory]/image-name.tar
I have an Bin file, I don't have the tar file.
Do you know If I can use this command with this Bin file?.
Thank you, best regards.
Policy based routing - is part of route maps. Coupled with an access-list & set next hop routing = PBR.
All the above are in ALL versions of IOS I belive.
I found it:
Â¨Â¨Â¨The Cisco Catalyst 3560 is available with either the IP Base or IP Services software images. The IP Base software includes advanced QoS, rate-limiting, ACLs, and basic routing and IPv6 functionality.
The IP Services software provides a richer set of enterprise-class features, including advanced hardware-based IP unicast and IP Multicast routing as well as policy-based routing (PBR)Â¨Â¨Â¨.
So, I need to upgrade to IP Services software.