If your switch infrastructure is solely two Nexus 5010 switches and two Nexus 2148T fabric extenders, is it possible to setup vPC?
I had tried doing this and seemd to be running into issues with the peer detection. I have switch SW-A with one attached fabric extender FEX-A and a second switch SW-B also with one attached fabric extender FEX-B. The mgmt0 interface of each switch connects to a port on the FEX that is connected to the other switch. VLANs are used extensivley to slice and dice the network around firewalls that are attached to these switches as well.
I don't have my vPC config attempt handy right now. Just looking to see if anyone knows if it is possbile to set this up if there are no other switches invovled to provided connectivity to the management ports outside of the Nexus hardware.
Hello guys.I installed remote access VPN on Windows 2019. I need to do additional configuration on the router to allow access outside. I got this.Public IP--------------ISP Router-------------Fa0/0 Cisco Router Fa0/1------------------------My Server ...
Meet the Authors video - How to Troubleshoot Network Problems with Vinit Jain
(Live event – Wednesday, February 12th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event had place on Wednesday 12th, February 2020 at 10hrs PDT&nbs...
I have a pair of 3945 routers that are proving to be underpowered for the 100+ remote offices connecting to them. Fortunately I happen to have a couple of 4351 ISRs rated for significantly greater encrypted throughput. Is there any way I could upgrade the...
This article assumes you have the basic knowledge and experience with Cisco DNA Center and Identity Services Engine (ISE).Note when reading this doc the "Authentication Policy" referred to is part of Cisco DNA Center Onboarding section and ha...