02-16-2022 01:32 AM
Hi Community,
I've made a VRRP setup between Cisco & Juniper device as below:
1/ On the Cisco devices:
- Two interfaces connected to the Juniper devices:
Gi1/1 (mode access )--> Junipr 1
GI1/2 (mode access ) --> Juniper2
The L3 config is under an SVI (the vlan id is being extended to the juniper devices).
2/ VRRP config on the Juniper device
The issue is that I can't ping the VRRP IP from the Cisco device. On the ARP table, I'm seeing only the real IP addresses of the Juniper devices.
Does anyone experience the above, I'm planning to change the configuration to trunk mode but I'm not sure that it will fix this issue.
I need your assistance here, thank you in advance!
02-16-2022 03:59 AM
- Check if these info-resources can be useful :
https://blog.marquis.co/vrrp-between-cisco-and-juniper-switches/
https://ultraconfig.com.au/blog/vrrp-configuration-between-a-cisco-ios-xe-and-junos-router/
M.
02-16-2022 05:10 AM
Hi @marce1000,
Thank you for your help.
But in my case, there is no VRRP config on the Cisco device. It's only on the Juniper devices.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide