11-02-2017 03:38 PM - edited 03-08-2019 12:36 PM
Hi All,
I'm looking for the following command dual active-exclude interface *** on the 4500x however it doesn't seem available. So when the VSL fails the switch that goes into recovery mode shuts down all interface's except management and the VSL port, however i want to specify other interfaces not to be shutdown during this process, can this be done?
test-switch(config-vs-domain)#dual-active ?
detection Dual-active detection enable
recovery Recovery IP address
Thanks
Solved! Go to Solution.
11-02-2017 06:06 PM
11-02-2017 04:15 PM
Hi,
This command is not available on the 4500 series VSS switches. It is only available on the 6500 and 6800 series switches.
HTH
11-02-2017 05:58 PM
I take it there is no command to replace it on the 4500X?
Thanks for your prompt response.
11-02-2017 06:06 PM
That is correct. There is no command that I can find.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: