Hello Experts
1. Just a quick check : the way we configure VSS on 6500 is it similar on 6800 (6880 / 6807) as well ?
2. Below is some VSL QoS setting for 6500 on cisco site - is it similar on 6800 also ?
-
VSL is a critical internal control and data communication path, and hence QoS settings are pre-configured and configuration changes are not allowed.
-
VSL is always configured as Trust CoS and ingress queueing is enabled.
-
Only CoS based trust and queuing is supported currently. Service policies are not supported on VSL.
-
QoS policies must be applied at the input interface of the flows.
-
Priority queue is enabled by default. VSS control traffic and BPDUs are given high priority on VSL link.
Any quick help is appreciated.
Thanks
