vss standby chassis reboot trap

[raindrop18]

I have multiple 6509 vss switch. and i notice when the standby chassis reboot I didn't get any snmp trap, but I got when the active one reboot. my question is is there any mib out there for detecting and got a trap when standby reboot? thanks.

[Reza Sharifi]

Have you tried this command?

snmp-server enable traps vswitch

HTH

[raindrop18]

thanks for the response. yes I have the following commands on my config.   

snmp-server enable traps vswitch vsl

so that only work for dual active or both the active and the standby failed.. as I said I am looking for for theses 2

Active Supervisor Engine Failure (=Active Virtual Switch Chassis Failure)

Hot-standby Supervisor Engine Failure (=Standby Virtual Switch Chassis Failure)

thanks.