cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1273
Views
0
Helpful
2
Replies

vss standby chassis reboot trap

raindrop18
Beginner
Beginner

I have multiple 6509 vss switch. and i notice when the standby chassis reboot I didn't get any snmp trap, but I got when the active one reboot. my question is is there any mib out there for detecting and got a trap when standby reboot? thanks.

2 Replies 2

Reza Sharifi
Hall of Fame
Hall of Fame

Have you tried this command?

snmp-server enable traps vswitch

HTH

thanks for the response. yes I have the following commands on my config.   

snmp-server enable traps vswitch vsl

so that only work for dual active or both the active and the standby failed.. as I said I am looking for for theses 2

Active Supervisor Engine Failure (=Active Virtual Switch Chassis Failure)

Hot-standby Supervisor Engine Failure (=Standby Virtual Switch Chassis Failure)

thanks.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: