11-03-2022 09:42 AM
standby switch went into standby cold state instead of standby hot.
We rebooted standby switch but still same output.
Switch 2 Slot 11 Processor Information :
-----------------------------------------------
Current Software state = ACTIVE
Image Version = Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSAL-M), Version 15.2(2)E3, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2015 by Cisco Systems, Inc.
Compiled Wed 26-Aug-15 07:03 by prod_rel_team
BOOT = bootflas:cat4500e-universal.SPA.03.06.03.E.152-2.E3.bin,1;
Configuration register = 0x2101
Fabric State = ACTIVE
Control Plane State = ACTIVE
Switch 1 Slot 1 Processor Information :
-----------------------------------------------
Current Software state = STANDBY COLD-BULK (switchover target)
Image Version = Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSAL-M), Version 15.2(2)E3, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2015 by Cisco Systems, Inc.
Compiled Wed 26-Aug-15 07:03 by prod
BOOT = bootflas:cat4500e-universal.SPA.03.06.03.E.152-2.E3.bin,1;
Configuration register = 0x2101
Fabric State = ACTIVE
Control Plane State = STANDBY
Cannot execute command on peer supervisor because it is not in SSO Standby state
Solved! Go to Solution.
11-10-2022 08:42 AM
Its resolved by rebooting both switches and failover to other one ....
11-03-2022 10:16 AM - edited 11-03-2022 10:17 AM
Can you post complete output :
#show redundancy
why your -Configuration register = 0x2101 (it should be 0x2102)
other thing, should be bootflash ? or is this typo :
bootflas:cat4500e-universal.SPA.03.06.03.E.152-2.E3.bin,1;
11-10-2022 08:42 AM
Its resolved by rebooting both switches and failover to other one ....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: