VTP Pruning, when the network also has non cisco devices.

[Alexandros Mavridis]

i have for example 20 Switches and two of them are no cisco Switches and then they are not working because the dont have vtp, what must doing for this 2 switches ?

[Joseph W. Doherty]

Configure their VLAN information, manually.

[Alexandros Mavridis]

i have for examble  Cisco SW  trunk->Cisco SW trunk->Cisco SW trunk-> 10 Devices

with show  interface trunk i see the vtp pruning is ok i see onlz the vlans for this 10 Devices  but when i have  Cisco SW  trunk->Cisco SW trunk->Cisco SW trunk-> NO Cisco SW -> 10 Devices with show interface trunk i see vlans 1-500 and not the 10 active vlans 

[paul driver · Accepted solution]

Hello

VTP/pruning is cisco proprietary so it wont work on non Cisco hardware, suggest you manually prune you vlans on the trunks and create you vlans on the non cisco hardware if applicable

res

Paul