cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
171
Views
0
Helpful
1
Replies

WAP131/321 on Cisco 3560 switch

theascott
Level 1
Level 1

Hi all.

i am trying to connect cisco wap131 and 321 access point to cisco switch 3560 48port, as soon as i connect, the port turned off in 1 sec and turned on after 5 mins when i remove connection, this is happening with any port. 

can some one help me to solve this issue. switch is managed and few vlans configured, i am connecting WAP into dynamic zone vlan.

Thanks in advance.

1 Reply 1

Mark Malone
VIP Alumni
VIP Alumni

Are the ports on switch going into err-disable , did you get any logs to see what's happening on switch side when AP is connected  ?

whats the running-config of the port your connecting to , need information of the switch if were going to be able to assist further  

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: