cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
287
Views
0
Helpful
1
Replies
Beginner

warm reload

Hi all,

I have a probleme with warm reload on a cisco 2911 Version 15.2(4)M1.

I read a manual that told me just enable warm reload by using the command "warm-reload" and a simple reload after that.

Failure during the reboot: "WarmReboot:compression failed while saving data"

sh flash:

153436160 bytes available (103051264 bytes used)

Do I have enough flash?

Thx 4 reading

Paul

Everyone's tags (5)
1 REPLY 1
Highlighted
Cisco Employee

warm reload

Hi Paul,

please increase the I/O memory on the device through following command and

capture the console logs.

#memory-size iomem 25

Once you increase the I/O mem , please collect the output of #show memory statistics

command.

Once this has been configured and not resolved then proceed with software upgrade  to 15.1(4) M5.

HTH

Regards

Inayath

CreatePlease to create content
Content for Community-Ad