Hi folks,
I was trying to configure a secondary IOS file for bootingon 2960X switch. Actually i was doing a IOS upgradation, & as precaution I'm keeping old IOS file in the flash & trying to make it as secondary image to boo,t in case switch with new IOS is not able to boot , it would fall back to old IOS & boot with it.
I've seen the some sugguestions of putting multiple "boot system" command in order in which I want it boot with, but that seems not the case over here coz I'm not able to see "boot system" command in the show running-config.
Please suggest if there's a way around for this!
