03-04-2019 01:53 AM - edited 03-04-2019 02:25 AM
Hello,
We have a few catalyst 2960 with SFP-10GBase-SR sfp moduls. The PRTG send me a warning message, that the value is too low. If I check on the swtch via Sh int transceiver I can see the value (I attached the screenshot)
But the PRTG table say -2,50 (1066) is above the warning limit of -14 in 1066.
What should I do?
Try to renoumber on the PRTG sensor?
Thanks,
Tamas
Solved! Go to Solution.
03-04-2019 08:13 AM
Hi,
If the optic is working fine for you, just disable the alert on PRTG or modify the threshold so you don't get that message.
HTH
03-04-2019 08:13 AM
Hi,
If the optic is working fine for you, just disable the alert on PRTG or modify the threshold so you don't get that message.
HTH
03-12-2019 08:52 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: