06-14-2012 04:29 AM - edited 03-07-2019 07:14 AM
Where can I find a sample working config of Cisco (HP rebadged) 3120 Blade Switch ?
I have the Cisco 6500 end configured as follows:
=====================================
interface Port-channel1
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,300,304,310,320,560-562,600,740,770,950
switchport mode trunk
load-interval 30
interface TenGigabitEthernet9/5
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,300,304,310,320,560-562,600,740,770,950
switchport mode trunk
udld port disable
channel-group 3 mode active
interface TenGigabitEthernet9/6
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,300,304,310,320,560-562,600,740,770,950
switchport mode trunk
udld port disable
channel-group 3 mode active
I will be connecting 9/5 and 9/6 to Cisco 3120G (HP rebadged) Blade Switch in c-Class Enclosure tomorrow.
It would be nice to have a rough sample configuration of the above 3120G switch.
Can someone point me to a sample config document or post a sample config here as reply if they have one.
Alphonse
06-14-2012 04:30 AM
Note: I wish to run LACP between the Cisco 6500 and Cisco 3120G. Forgot to mention this before.
06-14-2012 04:34 AM
Hi,
There are examples for different situations in the configuration guide:
Check those aftre the commands explanations.
Kind Regards,
Ivan
**Please grade this post if you find it useful.
06-14-2012 04:47 AM
Thanks Ivan. I will read it.
Do you know if there is any sample config in somewhere.
Thanks again
06-14-2012 05:52 PM
3120 is basically a switch in a slot so it should follow normal lacp creation guidelines.
06-14-2012 10:11 PM
Hi,
Yes, in the guide by this link I posted there are some examples, e.g.:
Switch# configure terminal
Switch(config)# interface range gigabitethernet2/0/4 -5
Switch(config-if-range)# switchport mode access
Switch(config-if-range)# switchport access vlan 10
Switch(config-if-range)# channel-group 5 mode active
Switch(config-if-range)# exit
Switch(config)# interface gigabitethernet3/0/3
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 10
Switch(config-if)# channel-group 5 mode active
Switch(config-if)# exit
And as Glen mentioned, it acts as a normal switch, so the LACP is created the usual way.
Kind Regards,
Ivan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide