Hi , I have an problem started with me since a period not a few , That I can't log in to the modem control panel via this link (http://192.168.1.1) even if i add (https://) to the link .. same result .
To log in I must to unplug the modem from its wire then wait 5 seconds then plug it , After that I'll be able log in to the modem control panel !
For knowledge, I didn't see this kind of problem before , I've tried most of the solutions like check modem settings , and reset the modem many times and others .. all these attempts to restore the default settings , but the problem still ongoing .
So , Can anyone help me how to solve the problem in details please .. Thanks in Advance .
Hi Guys, I have two questions about EIGRP behavior when we have Multiple EIGRP routes: 1- I tried to show on some router the acquired EIGRP paths for a route X.X.X.X by typing the command : "show ip eigrp topology X.X.X.X". On the output there w...
[ The Discussion forum will be published on December 1st ]
Take the opportunity to reach out to our expert and discuss best practices regarding on how to troubleshoot a live network and identify the root cause easily. Learn more about Serviceability and h...
To provide a solution to quickly setup a router at a remote location that supports WiFi and provides instant internet access using LTE as a transport while deploying with Cisco SD-WAN.
Plug the router to a power sou...
Hello!I'm looking for a way to make my EEM script more dynamic and automated for my environment. This is what I have - basically I just capture the 4 IPSec peer IP addresses of each neighbor and insert this data into 4 different variables. ...
Hi all,I have a couple of Nexus9k switches. I need to get tcpdump from the physical interface which connected to the server. I'm looking for a specific protocol on tcpdump so that which feature should I use? I asked that because I couldn't full...