06-08-2015 05:45 AM - last edited on 03-25-2019 04:34 PM by ciscomoderator
why no loop in topology but the trunk port (uplink) have error SPANTREE-2-LOOPGUARD_BLOCK
is it safe to remove loop guard config to resolve this network problem which sometimes online and sometimes offline
06-08-2015 07:38 AM
check command show spanning-tree inconsistentports you may have a udld failure , is the port blocking on the uplink in STP?
06-08-2015 08:26 AM
If the ports is not blocking on the uplink, you need to check the physical layer first to rule there is no bad cable.sfp etc.
Also good to check cpu utilization on this switch and also on the uplink switch. The port is going to loop guard error since it is missing BPDUs from the other side.
Thanks,
MAdhu
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: