WRV210 DHCP Active IP Client Table in blank

[jakubtesinsky]

Hello,

my DHCP Active IP Client Table in blank eveen though IP's are beeing assigned and internet connection works. However it is very inconvinient when connecting new computers to network. Sometimes it is not blank, but has one or two entries.

Some facts:

• I have WRV210 router.
• I do not have PS2 on my network.
• I did disabled UPNP under Administration / management (as many post suggest)
• I do not use any windows firewall on any computer (in fact I do not use Windows).

Any ideas how this can be repaired? I can do any sorts of experiments, but after having tried everything from other forums discussing similar probles I ran out of ideas.

Jakub

[paolo bevilacqua]

This forum is for IOS Cisco routers.

For your problem, post in Small Business, routers.

[abudef000]

Hi Jakub,

are you sure your network devices have aquired fresh IP adress from WRV210? When devices are turned on and there is a switch between DHCP server (WRV210) and devices, devices don´t need to ask for a new address (network connectivity is still available even if you restart/disconnecting WRV210).

Try this: 1) Turn on WRV210 2) Turn on or restart all DHCP client devices 3) You should see all assigned IP adresses in that table.

Regards,

Abudef000