WS-C2960+24TC-L Bootup issue

[Arsalan Noor]

Dear folks,

i have cisco 2960TC-L 24port switch, but after start just mode light is blinking continuously while console view has shown abnormally language. i.e -30)/@<><?|}{|}|}"|")|_|?}|()*^&*^&*|"|":}|P"|/@<><P:P}":P"}P"P"P:|?/@<><>?<><<<. even any key type but abnormally language is showing. if anyone have faced this issue pls let me know.

[Reza Sharifi]

Hi,

On your console settings, try a different baud rate from 9600 and go up.

https://www.cisco.com/c/en/us/support/docs/dial-access/asynchronous-connections/9321-terminal-settings.html

HTH

[Arsalan Noor]

Tried but still same.

[marce1000]

   - Try tapping the space bar during boot, check if that helps.

 M.

[balaji.bandi]

can you post the baud rate setting and let us know what terminal emulator you using?