WS-C2960S-24TS-L-UPDATE ISSUE-152-2.E9

[ciscoreg2]

Hi,

My switch was WS-C2960S-24TS-L, after upgrade to 152-2.E9, the switch unable to boot up, below was the error:
File "flash:c2960s-universalk9-mz.152-2.E9.bin" uncompressed and installed, entry point: 0x3000
executing...
Loading "flash:/c2960s-universalk9-mz.152-2.E9.bin"...

File "flash:/c2960s-universalk9-mz.152-2.E9.bin" uncompressed and installed, entry point: 0x3000
executing...
Boot process failed...

anyone has same issue?

[ciscoreg2]

Did you want to see c2960s-universalk9-mz.152-2.E9.bin if exist? I have delete and upload for several times from xmodem and tftp. But it does exist.

[jmartinez20]

Yes, I need to see if the image size matches or if there is anything Else it’s trying to boot from.

[ciscoreg2]

dir flash:
Directory of flash:/

2 -rwx 5479 Jun 20 2019 21:46:16 +08:00 private-config.text
625 -rwx 3096 Jan 2 2006 08:01:47 +08:00 multiple-fs
4 -rwx 16800768 Jun 20 2019 21:35:51 +08:00 c2960s-universalk9-mz.152-2.E9.bin

[Leo Laohoo]

That error message, to me, sounds like the BIN fine is corrupted in some way.
Can you reboot the appliance again by PULLING THE POWER CABLE?

[ciscoreg2]

Yes, I have done several reboot...

[jmartinez20]

Do the following commands to boot from the following image.  or copy and paste. Make sure everything matches the same.

switch:BOOT=flash:c2960s-universalk9-mz.152-2.E9.bin

switch:boot

[ciscoreg2]

I did this command before, and it will show the error same as power-on after loading ios.

[Leo Laohoo]

Can you try loading, say, 12.2(55)SE train?