Apologies if this is in the wrong - this new layout is not the most intuitive.
We have upgraded a stack of 3850 switches to 16.3.6 from 3.6.3 where we used 802.1x for authenticating workstations attaching to the network.
After the upgrade there are no 802.1x options any more , how do we get 802.1x back or does the Denali image no longer support it ?
For reference pre upgrade the switchport config looked like this
authentication control-direction in
authentication host-mode multi-auth
authentication timer inactivity 60
dot1x pae authenticator
dot1x timeout quiet-period 65535
dot1x timeout tx-period 65535
dot1x timeout supp-timeout 65535
dot1x max-req 1
After the upgrade you do not even get the options
(config-if)#auth
^
% Invalid input detected at '^' marker.
(config-if)#dot
^
% Invalid input detected at '^' marker.
Regards