WS-X6K-SUP2-2GE redundancy

[Rene Paul Huet]

Hi,

I wish you a good year 2010

I have a 6506 with 2 WS-X6K-SUP2-2GE (in slots 1 & 2). Card in Slot1 is active and card in slot slot2 is standby.

All LEDs are green in card 1 (that's normal)

On the Card 2 (redundancy card)

• The Status and System LEDs are green (that's normal)
• Active LED is orange (It is normal for this card is in standby).
• The PWR-MGMT LED is off (and I don't know if it's normal).
  • The synchronization between the two cards are good.
  • A show module shows that all modules are well recognized.
    
  • A show power  shows power is good for all modules.
  • I don't have an error message that indicates a possible problem on the card
  • A show diagnostic module for module 2 indicate state Unknown
    
    

    Various Cisco docs indicate the LED PWR-MGMT may be red or green (but there is no indication on the LED off).
    

    • The problem is note hardware, because I have the same problem with an other 6500 (6509), I have already change the card.
    • The IOS version is 12.1(26)E6

    Please can you tell me if it's normal the power managment LED is of.

    I'm sorry for my English

    Best Regards

    René

Note :