X2-10GB-SR compatible with GLC-SX-MM??

[mkashifashraf]

Dear all,

one side Catalyst 6500 module with X2-10GB-SR=

otherside WS-C2960S-48FPD-L.

is both end compatible with each other.

[acampbell]

Hi,

You can not inter connect these 2 transceivers.

X2-10GB-SR is for operating at 10G

GLC-SX-MM is for 1G

They need to be the same speed and fibre type

Regards,
Alex.
Please rate useful posts.

[mkashifashraf]

WS-C2960S-48FPD-L uplink is SFP+, can we connect GLC-SX-MM on SFP+ ports??

[acampbell]

Hi,

From this link

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps6406/product_data_sheet0900aecd80322c0c.html

Cisco Catalyst 2960-S with SFP+ based ports:

• 10BASE-T ports: RJ-45 connectors, 2-pair Category 3, 4, or 5 unshielded twisted-pair (UTP) cabling

• 100BASE-TX ports: RJ-45 connectors, 2-pair Category 5 UTP cabling

• 1000BASE-T ports: RJ-45 connectors, 4-pair Category 5 UTP cabling

• 1000BASE-T SFP-based ports: RJ-45 connectors, 4-pair Category 5 UTP cabling

• 1000BASE-SX, -LX/LH, -ZX, -BX, -T,^* -FX,^* and coarse wavelength-division multiplexing (CWDM) SFP-based ports: LC fiber connectors (single/multimode fiber)

• 10GBASE-LR, SR, LRM, CX1 SFP+ based ports

* The Cisco Catalyst 2960-S with SFP+ does not support the GLC-FE-100BX, GLC-FE-100FX, or GLC-FE-100LX.

So yes the switch should support GLC-SX-MM

Also

http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_6981.html#wp128965

WS-C2960S-48FPD-L WS-C2960S-48LPD-L WS-C2960S-24PD-L WS-C2960S-48TD-L WS-C2960S-24TD-L

GLC-SX-MM GLC-LH-SM GLC-ZX-SM GLC-BX-D GLC-BX-U CWDM SFP GLC-SX-MMD GLC-LH-SMD

—

12.2(53)SE1

Regards,
Alex.
Please rate useful posts.

[Leo Laohoo]

WS-C2960S-48FPD-L uplink is SFP+, can we connect GLC-SX-MM on SFP+ ports??

The 2960S SFP+/SFP ports can take either, HOWEVER, you still can't connect an SFP to an SFP+ because both run on different speeds.