Technology and Support

No outbound calls possible

I'm having a weird issue on our Cube. I have an incoming dial peer that should match outgoing calls to any number with 000 dial-peer voice 1120 voiptranslation-profile incoming add_plussession protocol sipv2session transport udpdestination dpg 999inc...

ASA 9.20 no anyconnect vpn management profile?

Hello,we've 2 prod Firepower 4112 running 9.22 interim and a test Firepower 2110 running 9.20 (no 9.22 for 2110 available)I want to try to establish a anyconnect vpn management Tunnel but on the 2110 when I want to add a Client Profile under "usage" ...

Cisco Collaboration 14.0 Sandbox Not Available

Hello,I’ve noticed that the Cisco Collaboration 14.0 Sandbox has been unavailable for several days. I regularly use this environment for testing integrations and configurations, but it currently does not appear in the DevNet Sandbox catalog or shows ...

Inquiry about Deleting the Admin Account on Nexus 3548-XL

Hello, I’m using a Nexus 3548-XL running NX-OS 10.3(6). Due to a recent security issue, I’m trying to delete the default admin account. I have already created a new account with the network-admin role, but when I attempt to remove the existing admin ...

Layer2 Symmetric Load-Balancing

Hello everyone,For a scenario like the diagram uploaded, what is the cisco solution to symmetrically load balance traffic between servers and the switches work in active-active HA mode?I have used nexus 9k switches.I used vPC but it sends same flows ...

RBI Test Site

Is there a test site available to check whether Remote Browser Isolation (RBI) works? If there is a site that Cisco uses for testing, please let me know. If you have any experience with Cisco Secure Access or Umbrella, please let me know.

Adding 2nd ISP to existing [All] Cisco Network w/ ISP

Hello   So currently I have a DSL MODEM - FPR1010 - SG350XG. My Internet is DSL w/ 8 static IP's and the FPR does the PPPoE and is connected to the SG350XG with routing back towards the Internet... On the SG350XG I have 6 vlans [each single vlan is a...

Tracker and BGP attributes

I would like to create a endpoint tracker that monitors the next hop out the WAN/VPN0 side.  And based on the state of the tracker, influence BGP attributes.I've been using the newer configurations.  I can create tracker, but do not see where I can s...

Analog phones lines have stopped being able to send out.

We've discovered that multiple analog copper POTS lines that we have (Primarily for FAX), have stopped being able to send out, but can receive faxes fine. During the troubleshooting, a colleague & I have found the following. In the somewhat recent pa...

Jabber for Android and Bluetooth audio

Hi all!My company uses Jabber and I'm running the Android app (version 15.1.1.310240) and it doesn't route audio over to any Bluetooth device I have. All of them work natively with the Pixel Phone app but not Jabber.Is this a known issue, or is there...

Everytime Facing Same Error

Cisco 3750X And VLANS

Hi All,I am not a stranger to Cisco Switches, but a newbie to VLANs and have had some confusion with them. I am trying to implement a 9800 wireless lan controller. but I am putting it on hold until I get all my Vlans Setup correctly.I have a total of...

CBS250 meaning of "Switchport Mode" in GUI

Hey folks I'd like some clarity on what exactly the option "Switchport Mode" means in the GUI config of a CBS250. Specifically it's on the "VLAN Management -> VLAN Settings" page. The options are either Layer 2 or Layer 3, with a default of 2. The he...

Upgrade ASA 9.10(1)11 %ERROR: Signature not valid for file

I have FPR-2120, currently running ASA 9.10(1)11, when I try to upgrade it, I am getting %ERROR: Signature not valid for file disk0:/cisco-asa-fp2k.9.16.4.SPA. Below is my asdm and fxos version. Any help would be greatly appreciated. Been troubleshoo...