Activity in Technology and Support
Cisco ESS-3300-NCP - Software upgrade
Hello all, I am having a problem attempting to install the latest software. The software out of the box is extremely slow, clicking between the options in the webui takes between 1min to 2min to load. I was reading that updating the software would he...
Looking for mib file for small business switch SG500-28
I need to monitor several OIDs in my stack of SG500's (not SG500X's). I can snmpwalk the switch and get a long list of available OIDs; but I need the associated list of OID labels to figure out what each OID value represents. The switch's interface...
Intel(R) Wi-Fi 6 AX201 Connecting Only with Wi-Fi 5
Hi,I am using a Cisco vWLC 9800 with a Cisco 9105AXI-I AP. My phone connects with Wi-Fi 6 (802.11ax) successfully, but my laptop connects only with Wi-Fi 5 (802.11ac), even though it has an Intel(R) Wi-Fi 6 AX201 160MHz adapter.I have already:- Check...
Jabber for Android and Bluetooth audio
Hi all!My company uses Jabber and I'm running the Android app (version 15.1.1.310240) and it doesn't route audio over to any Bluetooth device I have. All of them work natively with the Pixel Phone app but not Jabber.Is this a known issue, or is there...
Cisco 3750X And VLANS
Hi All,I am not a stranger to Cisco Switches, but a newbie to VLANs and have had some confusion with them. I am trying to implement a 9800 wireless lan controller. but I am putting it on hold until I get all my Vlans Setup correctly.I have a total of...
Trouble using Break Key sequence to access ROMmon on a Cisco Router
Use Space Bar to simulate Break Key Sequence Read this article if you are trying to generate a Break Key Sequence to access ROMmon, and the Break Key sequence does NOT seem to make it to the router.Today, I needed to access ROMmon on an IR1101 Indust...
resaon for maximun path 2 under BGP
today I have seen maximum path 2 under bgp so why do we put this command ?Please explain
Upgrade ASA 9.10(1)11 %ERROR: Signature not valid for file
I have FPR-2120, currently running ASA 9.10(1)11, when I try to upgrade it, I am getting %ERROR: Signature not valid for file disk0:/cisco-asa-fp2k.9.16.4.SPA. Below is my asdm and fxos version. Any help would be greatly appreciated. Been troubleshoo...
Tracker and BGP attributes
I would like to create a endpoint tracker that monitors the next hop out the WAN/VPN0 side. And based on the state of the tracker, influence BGP attributes.I've been using the newer configurations. I can create tracker, but do not see where I can s...
CSCwn48408 - Cisco IOS XE Software HTTP API
Looking help related to bug CSCwn48408 currently running HTTP / HTTPS services in 9300 / 9400 and WLC's as well what would the best way to exploit the bug
Analog phones lines have stopped being able to send out.
We've discovered that multiple analog copper POTS lines that we have (Primarily for FAX), have stopped being able to send out, but can receive faxes fine. During the troubleshooting, a colleague & I have found the following. In the somewhat recent pa...
488 Not Acceptable Media E-Fax Setup Inbound
Faxing inbound does not work [outbound works from E-Fax].Faxing from internal fax number to internal fax number (E-Fax) doesn't work.Regardless of the way the fax is made, to the E-Fax, CUCM produces the 488 Not Acceptable Media SIP Response.See atta...
Basic ISE policy behavior
Regarding Authentication, when referencing the Internal Endpoint Database in policy, it seems to me that all profiled nodes will pass authentication since they all get populated into the Endpoint Database upon profiling? If true, the real access con...
Fast busy on outbound calls
Hello Everyone,Today I am going through an issue, I have never experienced.We have a CUCM and a 3rd party PBX, we have connected both the PBXs over a SIP trunk.I have created an Extension 2045 in the 3rd Party PBX and created a route pattern with th...
Cisco UBE (CUBE) Connected to CUCM and Teams Call drops (static)
Cisco UBE (CUBE) Connected to CUCM and Teams Call drops and goes to static from PTSNCalls from outside (PTSN) to CUBE to Teams drop after ring and replaced with Static noise. Anyone seen this before. We have 2 CUBEs and it was only affecting producti...
| User | Helpful Count |
|---|---|
| 108 | |
| 77 | |
| 75 | |
| 64 | |
| 62 |
