hello people I have a Cisco ISE 2.7 and want to upgraded to 3.1 and then to the recommended release, but the thing is it's using its own CA for the authentication so doy you have any recommendations for this procedure? I wanted to do a full upgrade, ...
We have a Multi context FTD3105 running ASA code version 9.22 and trying to build a site to site VPN with Azure . Can you please provide advice on the following ? 1 ) While trying to build a ROUTE based site to site vpn I was unable to create t...
Can someone please help me figure out why NTP is not being allowed when this ACL is applied inbound on the internet facing interface? everything else works but NTP broke and not sure why. interface GigabitEthernet0/0/0 ip address 1.2.3.4 6.7.8.9...
I have customer has two DCs with almost 10K endpoints, and I need to deploy for him Cisco ISE, which best practice should be applied and include HA?Also want to know Each endpoint count as active session? or endpoint can be multiple active session? b...
I am currently running 1 sip trunk and are using voice class e164-pattern-map XXX to route calls based on the inbound DID; all works great. I now have to add a second sip provider with a bunch of different DID's and point those calls to and from thi...
When trying to install a second switch and stacking to current live switch, both running 17.06.05, I get a lock-up state where all communication is lost with primary switch. What steps should I take to resolve this issue?
Hi All, I have a multi context FTD running ASA code and would like to peer one of the contexts to our Azure environment using a route based site to site VPN . I have created a new context solely dedicated to the VPN tunnel and configured resource...
I have some Cisco 7965 IP phones I need to dispose of. Company policy requires them to be wiped/factory reset before disposal. I have successfully wiped 8841s without issue. With the 7900 series after I input the factory reset number sequence the scr...
Hi we have an onprem cssm server, already have a dozen devices successfully connected but we cannot get our 9.2 MDS 9k added. tried all 3 method, callhome, smart and cslu, I read that only cslu is supported so sticking with that, the config is: lic...
Hello,I am new to the Cisco Self Standing Wireless LAN Controller System. I have always used Mobility Express, and I know it is end of life. The purpose of this AP is for learning and using it in my home lab. I have read this post below:Migrate ME to...
Dear Team, I unable to ssh the FTD device. No External authentication is configured. Local authentication enable. When ssh the device user name & password asking. After giving proper credentials access denied. But on same credentials we able to login...
Hello Team, I have a few POE "CCTV and aruba APs" that their interfaces do down then up again in few 30 to 40 seconds with no human interaction.I check the device and I see it rebooted "because POE".I am trying to understand the actual...
Good day, We are going to deploy DUO in the environment to protect Windows Logon and RDP. We will be using the Authentication Proxy (AP) to sync AD users to the DUO cloud. We are considering using 2 APs for redundancy. Do we simply configure both AP...
Hello everyone! Here are the release notes for our most recent updates to Duo. Public release notes are published on the Customer Community every other Friday, the day after the D-release is completely rolled out to commercial deployments. You can s...
