After upgrading the IOS-XE version, we have sometimes seen the following logs appear repeatedly- %DMVPN-3-DMVPN_NHRP_ERROR: Tunnel30: NHRP Encap Error for Resolution Request , Reason: protocol generic error (7) on (Tunnel: x.x.x.x NBMA: x.x.x.x) If w...
Thank you in advance for your responses on the following questions. Q1. In a working ISE Posture configuration, in the endpoint (client) side, what are the expected configuration files that we should see from within the client system? What are the ...
Hi Team, I am trying to establish ipv6 bgp neighborship in ASA but it is stuck in 'NoNeg' stateASA-1# show bgp ipv6 unicast summaryBGP router identifier 1.1.1.1, local AS number 100BGP table version is 1, main routing table version 1Neighbor V AS Msg...
Hello all, Currently I have several switches (IOS and Nexus) which use RADIUS for login. The RADIUS server is a Windows server and uses Active Directory authentication. I would like to assign the active directory users different privilege levels on t...
I launched a tacplus container and it's working great. The tac_plus.conf file contains the line accounting file = /var/log/tacplus-acct.log But since this is a container, we don't have access to the file system. Or is there a way to access the logs?
I have a Cisco 1552 E outdoor access point on a roof. It has a rollover RJ45 cable going from the console port on the Cisco AP down into a cabinet. I am looking for a compatible adapter to plug in this RJ45 rollover cable and then into my serial con...
Can Cisco 220 Series Smart Switches CBS220-24T-4G support : a) AAA TACACS+ integration? b) Remote access via ssh ( CLI)? c) Can I add other "not-VLAN1" VLANs for management? d) This model is not PoE, but could I add voice vlan ( for phones with powe...
Hey everyone.Just wanted to let you know that if you ever wanted to calculate queue and threshold depth of Catalyst 2960/3560/3750, now there is an easier way.By reverse engineering memory blocks a bit, I was able to figure out the memory structur...
Hello Community,I've got Catalyst Center running version 2.3.7.7 monitoring our devices with Assurance, handling SWIM, doing traditional networking CLI templates and integrated with ISE 3.3 (not managing policies, just setup in Network Settings for N...
Hi all,So we have a couple of Enterprise agents deployed but they are not showing up under Devices?Each time I go to the devices page I get showing the Deploy Enterprise agents.Were the agents deployed wrong?Anyone else had this?
Hi, Is it possible to provide the output of 'show ip interface brief' from an SD-WAN router that uses a PIM module with a dual SIM card? I am little bit confused by these statements : Only one SIM is active at a time.SIM switching is handled by the ...
I would like to change my primary email address.I did this at https://dashboard.opendns.com/myaccount/email and clicked on the confirmation link that was sent to me by email. I was then taken to the account overview page, but the email address is sti...
Hi,I have two scenario seeking advise:1) to take advantage of Fortigate Geo-Blocking and integrate it with ASA SSL-VPN, I setup ASA behind fortigate like this in a LAB and it works fine. let me know if there is any consideration: - ASA Port 4 as Outs...
I have a static route next hop with both output interface and address specified.I am aware that there is no significant change in operation, but please tell me the reason/intention for using them separately.Also, please let me know if there are any a...
