Activity in Technology and Support
Cisco EEM scripts
Hi Experts,Need your help one more time I am configuring EEM script for switches backup but i facing below errorsConfigured command - action 25.0 cli command "copy running-config ftp://CISCOSWITCH:Passwd@192.168.10.10/SWITCH/IN/$h/$h-$t abc.txt"Error...
PTP starts to jitter if e2etransparent clock is enabled on C9500
Hi there!I just observed some odd behavior on our C9500-48Y4C running IOS-XE 17.12.06aWhenever we enable the End-to-End transparent clock on the 9500, our ptp clients (attached directly to the C9500) the offset from master values starts heavily to ji...
The output of the "show env all" command shows the "RPS is FAULTY" error message even though Redundant Power System is not connected to Catalyst 2950 series switches
Core issueThe output of the show env all command can report incorrect information such as this output:Switch#show env allFAN is OKInternal POWER supply is OKRPS is NOT presentRPS is FAULTYThis problem is documented in Cisco bug ID CSCee96721.Resoluti...
ISE 3.3 Patch 8– /opt Disk Utilization Increase and Considera0tion P-9
Hello, After installing Patch 8 on Cisco ISE version 3.3 Patch-7, we have observed a significant increase in /opt disk utilization. The disk usage increased from approximately 22% to 56% within one month after the patch installation and this is only ...
Small Font Duo Security for Windows Logon
Hi All,Just wondering if we could customize the verification code font size?After update the latest software come with change with the graphical interface. Where it use to be big font for the code display.Regards,Peter Ho
Inter Tenant/VRF communication
I have two independent Cisco ACI sites (not running Multi‑Site): Site A and Site B. The sites are connected by a Layer‑2 EtherLine link, and we run OSPF to provide Layer‑3 connectivity between them. Site A have two tenants: Tenant‑1 and Tenant‑2. Ten...
How to configure STP for an RSPAN aggregator switch to analyzer?
Hi,I'm using an old Cisco 3750x as an aggregator switch for a number of other switches which are configured with an RSPAN vlan. The Cisco 3750x then has the uplink port connected to a passive network monitoring sensor which ingests all the SPAN traf...
EoV date for APs
Hi Team, My customer is trying to find out how to get Cisco API to provide EoV dates for APs. They commented that all of their APs are without a date while all other devices have the EoV filled in – which could indicate that it is an AP related topic...
Cisco Secure Firewall Migration Tool and FTD version
Hello, I am planning to migrate a pair of ASA 55xx to Secure Firewall 3105 hardware and planning to use the FMT tool. Should I use the same version of the migration tool as the FTD version I am planning to install or just install the latest version o...
Firmware and boot code for SG300-52MP
Hello to all,last night power fall out and after that my cisco SG300-52MP doesnt work right. Only green power led blinking and yellow PoE led lighting. I think, firmware is corrupted. I search for firmware and boot code for this model, but no success...
Resolved! Reimage Cisco FTD 1120 - empty disk, missing correct FXOS
HelloBeen struggling with a Cisco 1120 today, no warranty left, but would like to get it running again. Tried a new disk and flashed it with tftp from rommon, also tried USB. Unit comes up with FXOS, but not able to install FTD with scope --> firmwar...
Move a chassis from old FIs to new
Hi Community members, we have an Intersight managed mode UCS environment. Plan is to move an existing chassis that is connected to 6400 FIs to the new 6664 FIs. We going to free up the chassis so that no vms are running on the blades which run ESXi. ...
Connectivity Issue between Cisco IE9320 switch and Huawei Router
Hi,i am facing an issue between Cisco and Huawei 1G Single mode SFP on industrial switch IE9320-24T4X as the link not come up while its working normally on Cisco IE4000 or C1300Cisco Side SFP: GLC-LH-SMD Huawei Side SFP: LTD1302-BC+1Has anyone this i...
ASA 9.20 no anyconnect vpn management profile?
Hello,we've 2 prod Firepower 4112 running 9.22 interim and a test Firepower 2110 running 9.20 (no 9.22 for 2110 available)I want to try to establish a anyconnect vpn management Tunnel but on the 2110 when I want to add a Client Profile under "usage" ...
Can customer remove the SSD in a ASR-9922-RP-TR product by themselves?
A customer is asking the possibility to remove the SSDs in a router processor (A99-RP2-TR) before return it to Cisco, due to the data security concern. I checked the genealogy of the product with a SN in Cesium and found there was no children SN list...
| User | Helpful Count |
|---|---|
| 124 | |
| 84 | |
| 53 | |
| 44 | |
| 36 |
