Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are having a SIP call recorder which is recording calls via Built in Bridge functionality. While fetching events from JTAPI, we are encountering below error. Can you please confirm what might be causing this. We have given all the necessary permis...
Hi All,Recently, we migrated our enterprise Wi-Fi authentication method from PEAP to TEAP (inner auth EAP-TLS). Since then, many users have been experiencing disconnections while their sessions are active.In the morning, the Wi-Fi connects and works ...
Hello, everyone. Why are link-local addresses that are used for next hops advertised in type 8 LSAs? Doesn't the router already know them considering that they are used to form the OSPFv3 adjacency? Thank youDavid
I have CUC ver 14 with CUCM ver 14 / Was working with call handler and vm pilot now its all busy. I have tired SIP integration and SCCP integration. Thanks
Hi Everyone!I am receiving this error message in Zabbix when trying to establish SSH Connection to my Nexus switch"Bad server host key: Invalid key length" I am suspecting the RSA key length. Because i checked the length in my switch and it is only 1...
Hi,can anyone tell me why Cisco is not allowing address reservations outside the defined DHCP pool?At least on ASA and FTD thedhcpd reserve-address xxx.xxx.xxxx.xxx abcd.ef01.2345 insidealways needs to be inside the specified pool.I mean there is a w...
CUCM ver 14, phone 7841. Line 2 or 3 does not give option of CallFwd on softkey.Can not find in Admin guide how to make the 2nd or 3rd line have an option of Call Fwd (on/off) with a softkey. Only found can do it with user logging in to Self Care , ...
Hi friends,I was trying to set SDWAN controllers timezone to IST but i did not get any such options in Command prompt, It gives me a UTC options only and no asia region shows in command prompt.If you have any command prompt or document to configure t...
Hi, I have 4 multicast sources sending traffic each to two multicast groups, as follows: 10.65.190.1 -> 224.64.64.110.65.190.1 -> 224.64.64.510.65.190.2 -> 224.64.64.110.65.190.2 -> 224.64.64.5 The traffic enters the router via a VLAN interface con...
I want to know about how a Switch forward it's control plane traffic like cdp/vtp/dtp messages on a trunk. Will they be forwarded with tag or untagged and why??
Hi All, I'm doing some self-guided Wireshark training on Udemy in order to better understand and troubleshoot my network. One of the topics today was retransmission, which I see a lot of in my captures and something I haven't been able to understand...
i have had the system i have in place for some time and had no problems, when using a 2 router approach [isp1 and isp2] but since i merged both onto 1 device, ISRC111 there is an issue with incoming connections via isp1. i am using the same acl's and...
I read that CDP, VTP, and PAgP updates are always forwarded on trunks with a VLAN 1 tag. https://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-series-switches/24330-185.htmlBut what I saw in the capture that these updates(I just checked c...
