hello people I have a Cisco ISE 2.7 and want to upgraded to 3.1 and then to the recommended release, but the thing is it's using its own CA for the authentication so doy you have any recommendations for this procedure? I wanted to do a full upgrade, ...
Hello,I’m preparing to deploy a Windows Server 2025 Hyper-V cluster on a Cisco UCS X9508 chassis, and I’d like to understand the best practices for this setup.In particular, I’d appreciate advice on the following points:Recommended firmware versions ...
I am trying to configure the Presence Gateway for an integration with Office 365 and failing miserably at the Presence Gateway FQDN. All it says in the guide is that the Presence Gateway field should have either the fully qualified domain name or IP ...
Dear Community,I’m facing an issue with a single-TLOC Cisco SD-WAN branch (Catalyst 8200/8300 on IOS XE 17.15.03, vManage 20.15.03) where the WAN Edge fails to establish BFD Tunnels with other sites even though it can reach the Cisco-hosted Controlle...
Hello Community,I have configured my Cisco Firepower Management Center (FMC) using the UI. Now I want to retrieve these configurations using any of the following methods,CLIAPIFile ExportAlso, I want to verify whether my device setup is correct.Any g...
I used to be able to do a "show arp vrf all | inc x.x.x.x in the 9000 series routers. We recently switched over to 8500 series. It appears I can't do that command. Is there a work around?
after an acquire other company i have in lab an ASR1002-HX with 16.9.7 fuji fw version. As i see the box have RTU licenses not smart. Question is for what bandwidth is this box useable with rtu licenses without aby smart licences? Does it support 100...
Hi, I still don´t fully understand the licensing in relation to Cisco ASA Firepower Licensing. I already asked a question regarding the FMC here: https://supportforums.cisco.com/discussion/13086371/firesight-license-60-not-needed. I learned, that fo...
Hello everyone I'm going to upgrade cisco ISE from ver 3.1.0.518 patch 10 to version 3.3, so I want you to ask could I downgrade back to 3.1p10 from 3.3 if smth goes wrong?
Use Space Bar to simulate Break Key Sequence Read this article if you are trying to generate a Break Key Sequence to access ROMmon, and the Break Key sequence does NOT seem to make it to the router.Today, I needed to access ROMmon on an IR1101 Indust...
Hi,in FMC 7.4.3 we use Admin external auth with Active Directory (LDAPs).AD Admin says FMC uses NTLM and we have to change to Kerberos.I can't find Kerberos mentioned in FMC Admin documentation.Is it possible to change to Kerberos?regards,Thomas
Hi, We have a lot of laptop on which SecureClient is installed with Compliance Module We would like to upgrade the compliance module version, but we wonder if the download request to update this module can "kill" our ISE servers (2 PSN are used for...
During the Cisco ISE upgrade process, the following error appears: Current version: Cisco ISE 3.2 Patch 6 Upgrade Bundle download failed: Be sure that all your software is working stable, check your system on UI page (Administration > System > Hea...
Hey, I'm using passiveID on cisco ise. I installed the PIC agent and the agent shows green, however, when i ran the AD diagnostic tool i get two fails:1. Kerberos check SASL connectivity to AD2. Kerberos test obtaining join point TGTI checked the DNS...
Good afternoon,We are trying to create a button that helps us display a URL both on the touch screen and on the television. The script is as follows: const config = { button: { name: 'Web View', // The main button name on the UI and its Panel Pag...
