Activity in Technology and Support
IE-3400-8P2S has no space to update from 17.09.04a to 17.12.5
Hi all,I am using dnac to attempt to update my IE3400 switch software version however it won't proceed due to complaining about drive size, not enought space. I have already ran the commands to clean up anything inactive and I have 1Gb free space, th...
9800 Auto-Anchor with local APs and SSID
Have a client that has a 9800 auto-anchoring a quest network for several locations. The 9800 Auto-Anchor is at a site where they now want to host an AP and a local SSID. It has been my understanding that the auto-anchor should be used only for an a...
Resolved! Abandoned Call Report
We'd like to run a report that lists all the calls that were missed today. This should allow us to call these people back ASAP. The "Abandoned Call Detail Activity" report in UCCX Historical Reports only lists the calls that we not answered by agents...
Unable to upgrade FTD firmware on ISA 3000 Firewall
Hello everyone,We are running an ISA 3000 firewall currently imaged with FTD firmware version 7.4.2.3-4. The firewall is a single stand alone device, managed through FDM. We do not have FMC.Cisco has updated their "Golden Standard" version recently t...
Resolved! Cisco CP-8861 3PCC unable to dial using call history list.
We have Cisco CP-8861 3PCC phones that are unable to dial out from the call history list.
Controller don't discovery the APs
Hello Dear i have controller 9800-40 dont discover APs 9176 ? anyone here faced same problem ?
vBond IP Addressing in Hybrid SD-WAN Deployment with MPLS and Internet
Hi everyone,I’m working on a hybrid SD-WAN solution where all controllers are deployed on-prem, behind a firewall.I have two types of connectivity available MPLS and Internet. During the device onboarding process:Devices using MPLS will have the vBo...
9200 upgrade fail because ssh got disconnected
Today I was upgrading remotely a 9300 IOS XE but suddenly while I was waiting after the command: install add file flags:file active commit There it was a disconnection for 1 minute with the ssh session and the Switch didn’t display the wizard again. ...
Adding int to Mgmt-vrf
Hi,N00b question, please be gentle!Swapping out a SG to a Catalyst switch (C9300) at home, and very much not familiar with IOS!I've configured a Mgmt-vrf, which includes interface 0/0 (the physical RJ45) and applied VLAN 1 / 10.0.1.5/24 to itHowever,...
Resolved! Temporary License for Virtual Secure Management Center
Here's the situation I'm in: My customer has a virtual FMC that manages the SFR modules in three ASA-5516s. That runs version 7.0 as we have found anything newer doesn't work.We are in the process of migrating off of the ASAs and onto three 1140s. I ...
Cisco asa 5545XseriesHi,
Hi can someone help me with the configuration of ASA 5545Xseries? I have the router to the 0/0 and one pc on 0/1.I want to use dhcp to have internet access.Can you please give me a complete example cause the previous asa i had were using different co...
SG350X-48MP no PoE with latest FW --- SG350X-24P PoE working
Hi to allI have two SG350X switches, a 48MP and 24P and wanted to upgrade them to the same and latest firmware.Unfortunately the 48MP delivers PoE only up to FW 2.5.5.47. I tried certain versions like 2.5.7.85 and also the latest image_tesla_hybrid_2...
automatic generating syslogs logs
hello all, i would like to ask you for advice. i would need to send from my devices each hour a syslog message (for example heartbeat_nameofdevice) each hour to Qradar. those devices are nexus 9K (9.3.9) and ASA firewall. i tried to configure it with...
Cisco UCS C240 BE M4 S2 | UCS-ML-1X324RU-G
Hello Freinds Pls Advise on the below RAM 32 DDR4 for Cisco UCS C240 BE M4 S2 if it's okay for this box UCS-ML-1X324RU-G - Cisco 1x 32GB DDR4-2133 LRDIMM PC4-17000P-L Quad Rank x4 Replacementthanks a lot
unable to add vrf into a interface
Hi Team, vrf already created, however I am not able to add a interface in a specific VRF. Model: C1101-4P Getting below error: router(config-if)#vrf ?% Unrecognized commandrouter(config-if)#ip vrf ?% Unrecognized commandrouter(config-if)#ip vrf...
| User | Helpful Count |
|---|---|
| 185 | |
| 118 | |
| 90 | |
| 80 | |
| 77 |
