Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to know about how a Switch forward it's control plane traffic like cdp/vtp/dtp messages on a trunk. Will they be forwarded with tag or untagged and why??
I have an existing WLC contain Four branches only one of them will use SD-access. the other three branches will remain as a legacy all the AP using flex connect.for head office users in order to get the same IP for wire and wireless the WLC should be...
i have had the system i have in place for some time and had no problems, when using a 2 router approach [isp1 and isp2] but since i merged both onto 1 device, ISRC111 there is an issue with incoming connections via isp1. i am using the same acl's and...
Good morning Just a simple question about the physical design of a sd-access topology. Is it supported that an Edge Node is attached to another Edge Node ? Kind regards
I cannot find anywhere if the local admin account for FDM has a break class in any documentation. If say the account has been compromised. Can we console into the cli to reset the pw or do we have to reimage firepower and reload the configs?
I'm trying to configure a HWIC-16A as a terminal server without success. I can get a telnet session to connect, but I simply get a blank screen, no data appears to be sent or received over the serial line.The only similar post I could find was https:...
Hello, I'm currently configuring a site. They have isp that uses a radio link. I been having issues when the internal networks reach out to the internet that they are super laggy and slow speeds. Has any configure a site that instead of having a actu...
Hello, everyone. I understand that OSPFv3 separates links from prefixes and purposely moves the prefix information from T1/T2 LSAs into T8/T9. The RFC states the following: o The Hello packet now contains no address information at all. Rather,...
I have a Cisco Nexus 5672UP switch running NX‑OS 7.3(6)N1(1). The switch was functioning normally, but after performing a reset, the Ethernet ports on Slot 1 (ports 1‑48) are no longer visible in show interface status or show interface brief.
Hi together,has anyone an idea about the limitations with L2 flooding ?Our customer has a separate infrastructure with lots of L2 broacast domains (~100). This construct ist used for various sensors, terminals, ip-cams, etc...and some devices which m...
Hi All,Recently, we migrated our enterprise Wi-Fi authentication method from PEAP to TEAP (inner auth EAP-TLS). Since then, many users have been experiencing disconnections while their sessions are active.In the morning, the Wi-Fi connects and works ...
Hello everyone, Using IP MAC Binding option in Policy Profile is just about creating a binding table for itself or it can be used as a trusted source for features like IP Source Guard? Thanks
Hi,I have some MPLS VPN PE routers. I enabled marking on the LAN ingress interface and shaping on the WAN egress interface that is MPLS enabled.But marked ingress packets do not match on egress MPLS interface.What should I do?
Hello , can you please tel me if i need additional licenses something like Brocade Extended Fabrics for DS-C9132T-MEK9 switch? we have to connect two datacanters about 5 km far away from each other
