I don't pay for this internet monitoring or filtering. I'm on my home network and it often says "this site has been blocked due to content filtering" for various reasons. I don't know how your service or software is blocking my home network connectio...
Is it normal for conditional debug/radioactive trace to lose details when looking back several days? I had radioactive tracing setup for several MAC addresses over a weekend. I generated logs for a MAC going back 3 days. When I looked at the generate...
Hello,I recently went to the OpenDNS settings for Manage This Organization, then Plan info.However, after clicking on Plan Info, I get an error page that:The page isn’t redirecting properlyFirefox has detected that the server is redirecting the reque...
I have router a with a gre tunnel (tunn 1)to router b. Gig 0/0/0 to Gig 0/0/0i need to make another tunnel from A to a third on router C. C is connected to B on gig 0/0/1. No routing protocols it’s a small network all static’s. What’s the best way to...
I'm a new user of Cisco products in a public transportation agency and I'm working with both the Cisco 819 and 829 routers. These devices are installed on a large fleet of vehicles.We have written procedures for setting up both models, but the engine...
After install 802.1x I have the error's as:Feb 9 07:47:19.951 CET: %SYS-5-CONFIG_P: Configured programmatically by process EPM IAL Process from console as consoleFeb 9 07:47:19.954 CET: %SYS-5-CONFIG_P: Configured programmatically by process EPM IAL ...
Hello Team,I have a question. If the only way to change L2 MTU on Nexus5672 is globally using policy maps (this is also represented in the following guide https://www.cisco.com/c/en/us/support/docs/switches/nexus-9000-series-switches/118994-config-ne...
Hi All, we are facing an issue with Hunt group settings as below in the hunt pilot configuration we have given forward hunt no answer to a unity number(20562) where it will play a greetings . but while testing its showing dialling the unity number(2...
The following log message was output on Catalyst 9400 version 17.12.5.Is it safe to ignore this log?What does each log mean, what is the cause, and what is the recommended action? %FMFP-3-OBJ_DWNLD_TO_DP_STUCK: F0/0: fman_fp_image: AOM download to Da...
We are a small school that recently purchased some 9115 APs to cover individual offices. These were purchased through a reseller without a service contract. We are now looking to add some more 9115s through a new reseller, but being advised that, on ...
Greetings,I have aquired a second hand WS-C3650-8X24UQ-S. Appears to be working as is (connected to router and one pc), and no password. When looking up reset instructions, I see typically you flash_init, then delete config.text and vlan.dat (after h...
Hi AllI have a lab setup using DMVPN phase 3 with eigrp, a hub and 2 spokes.If I shut down the hub external IP, the spoke to spoke traffic fails within a few seconds.Is this normal? I know for redundancy you can have 2 hubs but would it still affect ...
