Hello everyone,There is a wireless network in use with AP2800 ME.I plan to link one more AP and change the SSID to a hidden SSID.The added AP operates normally and there is no connection problem. The IPs of all AP users connected to the controller AP...
Hi All. I would like to get your thoughts on the following issue i have been facing since implementing Dual ISP and failover for site-to-site vpn tunnels.Hub Site:ASA5515 using 9.6(4)42Spoke sites:Cisco ISRs using 15.1(4)M8, using voip services over ...
Hi All,I am newly building trustsec in my environment,trying to add one of the switch under trustsec. Have configured Trustsec settings and COA on the ISE for the switch and added the appropriate aaa commands , radius servers and cts commands.But sti...
Hi, how are you :). I have one question, about router Cisco 2911, and Juniper Netscreen 25, ver 5.4. I must start IP Sec tunnel between these two devices. I must use agressive mode, I saw this in configuration document. Question, how can I use agres...
I have upgraded cisco NCS-5504 router . Router was successfully upgraded but all the line cards are not showing. In platform command type is unknown and state is SW_Inactive.Regards Salman
Hello,At my home, I had an 8 port 2960G switch die after a power outage today. I replaced it with a ISR 1921 that has an 8 port ESM. It's been a very long time since I messed with configuring ESMs... My plan was to just copy over all of the switch...
hi,i'll be configuring a new N9K switch to replace a C9300.my question is, can i configure in advance the port-channel and vPC in the N9K even without the SFP inserted and fiber cables patched?just want to prepare the config so it will be a faster to...
You asked, we heard you! Introducing the ThousandEyes Support Community Capture the Flag event from April 23rd at 8 AM PST to April 29th at 5 PM PST. This month the ThousandEyes Community is offering two Capture the Flag missions in a single upcoming...
How can I enhance the reputation of the ip reputation on https://talosintelligence.com from poor? Our emails are being blocked by numerous customers utilizing the Cisco email security platform. i submitted the ticket but still remain unchanged.
Hello when a BD subnet is advertised over an OSPF L3out, i'm seeing tha subnet as E2 external route with metric 20 on the router connectd to BL (VPC link). Why the subnet is shown as external and not internal OSPF route? Why the metric is 20 ? Regard...
I work for a Cisco partner, have a professional-level engineering cert, and am trying to do a PoC for zero-touch provisioning. I purchased and expensed CML personal for that purpose because it included 8000v software with the code versions with which...
Dears,i have Cisco jabber and i need to lock it for a meantime or for long time// is there anyway to know which steps can help me to do that from settings?
Hello. We're currently running Meraki, and there is an issue we found. As far as I know, MX failover is automatically activated when the WAN is disconnected. If WAN Loss reaches a certain threshold, can't you force failover to Unit 2? Thank you.