Activity in Technology and Support
Policy Based IPSEC Tunnel With Firepower
If I am configuring an IKEv1 IPSEC site-to-site VPN with an FTD device running 7.4.1 managed by the FMC and it is policy based, not route based, does the system ACL applied to the device also control the traffic across the tunnel? If so, then what Zo...
IPSec VPN Tunnel Lan-to-Lan decrypt count zero
Hi, I have one issue with IPSec tunnel Lan-to-Lan between ASA 5525x (v9.8) and ASA FPR 2110 (v9.16). My Tunnel is up but ping between each client was not successful. Both peer status sh cry isakmp sa in "MM_ACTIVE".I ran packet-tracer icmp between pe...
Resolved! Best way to integrate ASA/ISE/Azure AD for MFA?
I want my VPN users on a Cisco ASA to authenticate against ISE but use Azure AD for MFA on the backend. So far, it seems there are three ways to do this. My requirements are that I must use AnyConnect and ISE. Setup Azure AD as External Radius Server...
Static Routes on FTD 2130 using CLI
Has anyone Created statoc route on the FTD sensor via the CLI?Mine looks like it goes throught bu when i FDM into it, i do not see them. Any Advice will be appreciated.Thanks.
redundancy in core layer
hi guys . i have a network with below topology. In the core layer, I want to have redundancy, which means that if the main core switch of my network has a problem, the backup switch will automatically enter the circuit. What method is there?
Resolved! I want to advertise only specific OSPF routes.
The route learned by OSPF from the LAN is re-distributed to OMP for publicity to other sites.I do not want to advertise the specific routes from OSPF. What kind of 'configuration' should we use ?I want to control this in the SD-WAN Router side, not t...
Setting a GRE tunnels between a NAT to a public IP.
Hi everyone.. i have been looking through multiple posts on the forum for similar cases but have not found the answer Im looking for.. I've been primarily using this thread for guidance. https://community.cisco.com/t5/networking-knowledge-base/settin...
cisco lock
hey.i need to know how can i lock my username for a time more than a month from my access not managerial access?
L2VPN Over GRE
Hi I'm trying to extended a L2 segment using MPLS L2vpn over GRE. I am able to establish the tunnel and get ospf and mpls adjacency also the xconnect between the peer is up but my 2 test pc cant reach each other. This is my PE3 config.interface Gigab...
ASR1001-X Thruput only 750 meg Interfaces10G both sides -Circuit 10G
We have a Cisco ASR1001-X and it can only pass 750 megs of traffic thru it on a 10 Gig circuit. I looked at licensing levels and they seem correct. Anyone have any ideas of what I can look at? Both Lan and Wan interfaces are 10 gig and Wan is using S...
Personal Account on CX?
Hello, I would like to know if there will be no discrepancy if I use a personal account on teh CX Cloud but for a company use? thank you.
BGP-LS ; how is BGP-LS data processed in BGP RIBS
Hello, I am working on collecting BGP-LS SAFI using BMP towards Cisco's opensource project Jalapeno. I have captured packets between RR and Jalapeno on each use case to observer where we see BGP-LS and where we DON'T see BGP-LS packets. few use cases...
Cisco 2960X and 9200L POE support for Paxton
Hi,We currently have a mix of Cisco switches from 2960s, 2960X and now the 9200L. However we are having issues with our Paxton POE door controllers. The 2960s work with all of our Paxton ControllersThe 2960X up to hardware version 4 work with the Pa...
wifi network drops during the day - AIR-AP2802I-Z-K9
Deal All, I would like your help regarding a problem that has been going on for a long time. Many users at the company have complained that the WiFi connection on their laptop drops several times during the day. I have been monitoring some of t...
| User | Helpful Count |
|---|---|
| 110 | |
| 79 | |
| 79 | |
| 74 | |
| 60 |
