I have upgraded cisco NCS-5504 router . Router was successfully upgraded but all the line cards are not showing. In platform command type is unknown and state is SW_Inactive.Regards Salman
Hello,At my home, I had an 8 port 2960G switch die after a power outage today. I replaced it with a ISR 1921 that has an 8 port ESM. It's been a very long time since I messed with configuring ESMs... My plan was to just copy over all of the switch...
hi,i'll be configuring a new N9K switch to replace a C9300.my question is, can i configure in advance the port-channel and vPC in the N9K even without the SFP inserted and fiber cables patched?just want to prepare the config so it will be a faster to...
You asked, we heard you! Introducing the ThousandEyes Support Community Capture the Flag event from April 23rd at 8 AM PST to April 29th at 5 PM PST. This month the ThousandEyes Community is offering two Capture the Flag missions in a single upcoming...
How can I enhance the reputation of the ip reputation on https://talosintelligence.com from poor? Our emails are being blocked by numerous customers utilizing the Cisco email security platform. i submitted the ticket but still remain unchanged.
Hello when a BD subnet is advertised over an OSPF L3out, i'm seeing tha subnet as E2 external route with metric 20 on the router connectd to BL (VPC link). Why the subnet is shown as external and not internal OSPF route? Why the metric is 20 ? Regard...
I work for a Cisco partner, have a professional-level engineering cert, and am trying to do a PoC for zero-touch provisioning. I purchased and expensed CML personal for that purpose because it included 8000v software with the code versions with which...
Dears,i have Cisco jabber and i need to lock it for a meantime or for long time// is there anyway to know which steps can help me to do that from settings?
Hello. We're currently running Meraki, and there is an issue we found. As far as I know, MX failover is automatically activated when the WAN is disconnected. If WAN Loss reaches a certain threshold, can't you force failover to Unit 2? Thank you.
Hi , Good day. I need some help to verify if there is any configuration issue from my end. Basically i have a registered LGW to the webex calling . The incoming call is working fine , but the outgoing call is getting the following error Outgoing ca...
Hello I am currently having trouble translating a configuration on a serial interface from a C3900-SPE150 to a C8300-1N1S-6TThe current configuration on the C3900 on the serial interface is as follows:ip address X.X.X.X 255.255.255.252encapsulation...
Hi AllWe have a codec plus that refuses to go into standby . It will go into half sleep mode but as soon as that period has ended the system immediatly wakes back up. The unit does not have a control system connected and it does not have a content...
Good morning friends,I have created two extended ACLs for in and out of my int vlan and applied it under int vlan for both directions inbound and outbound. I have created ACLs entries like this.For int vlan no. Out1 permit ip 10.1.0.0 0.0.255.255 hos...