Hi,I'm using FTDv 7 managed by FMC v7. Logging issues are there and there is an error about FTD not synced.So, first step seems to solve the ntp issues. FMC GUI is there for ntp which I set and it seems to be ok, but I cannot find where is the ntp se...
Hello everybody,our customer has a FMCv running sugg. rel. 7.2.5.1 and has a high CPU load of approx. 97%.(see attached screen dump).The VM has 4 CPUs, 32GB RAM and 250GB HDD.The FMC is managing a HA of two Firepower 1120 running rel. 7.2.5.A FMC reb...
See attached diagram. I have 3 routers (A,B,C) that are running IBGP. I have another router (D) that is connected to routers (B,C) and running EBGP. I am trying to prepend the as path from router D to router C so that the preferred return path is ...
I just wanted to clean up * decommissioned and * physically removed blade servers by * selecting one and pressing ["Delete"] at the bottom as usual from the inventory. But UCSM fails: "Operation is not permitted" Any Idea how to overcome this?
Hi, we use a custom file in /opt/cisco/uccx/document/System that we can read and write from an uccx application with System.getProperty("uccx.customer.dir"). We use the in UCCX Editor the Document steps "Create FIle Document" to get a document variab...
Hello, I know very little about configuring cisco hardware and need some help..... we are currently running an 1800 router and I obtained a new to me 1921 router and would like to replace the 1800 router with the newer one, I managed to get it factor...
The Cisco Document Team has posted an article. This document describes how to configure a customized Nexus role for TACACS via CLI on NK9. Know of something that needs documenting? Share a new document request to doc-ic-feedbac...
The Cisco Document Team has posted an article. This document describes the most common issues faced with the Attendant Console tool in Webex Calling (WxC). Know of something that needs documenting? Share a new document request ...
Hi All, My hyperflex cluster failed with the error "configure Service profile(SP) failed" "Associating Service Profile" during the UCSM configuration in each server but validation was successful. I have 6 nos of hyperflex UCS 240 m5 all-flash nodes a...
Router>Router>enRouter#conf tEnter configuration commands, one per line. End with CNTL/Z.Router(config)#Router(config)#Router(config)#Router(config)#crypto key ?decrypt Decrypt a keypair.encrypt Encrypt a keypair.export Export keysgenerate Generate n...
We're seeing a continuous string of the following messages on a 9407 running 17.9.5. Eventually the switch crashes. I can't find any info on what these messages mean exactly and whether we're looking at a software or hardware fault. The supervisor...
Hi Guys, i had this problem for 8 hours now and can't seem to get it cracked... after i input the command copy xmodem: flash:c2960-lanbasek9-mz.152-7.e9.binand using the SecureCRT going to Transfer > send xmodem I get this and after that nothing happ...
Hi,We have a customer using HCS. As part of this we set up Expressway for them during the first lockdown for them to be able to use Jabber remotely for voice only (no IM&P). They use the same domain name internally and externally e.g. abc.com Another...