cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
974
Views
0
Helpful
3
Replies

Are SX20 display the remote site video and pc presentation content simultaneously on single screen?

Halsser
Beginner
Beginner

I want to know if Cisco Telepresence SX20 Quick Set  has capability to create custom layouts to show the remote site video and pc presentation content simultaneously in one single screen , because I want to see the far end pc presentation and far end meeting video simultaneously in one single screen splitted to dual layout.

1 Accepted Solution

Accepted Solutions

Patrick Sparkman
VIP Alumni
VIP Alumni

If the SX20 is setup to use a single output, the far-end video and presentation content will be displayed on the same screen, you have four layout options: Equal, Prominent, Overlay, and Single.  Depending on if you're using a remote control or Touch 10 with the SX20, the layout controls are outlined in the below guides:

SX Series User Guide for Remote Control (CE8.2)
MX and SX Series User Guide for Touch 10 (CE8.2)

If you still happen to be using TC software on your SX20, refer to the other SX Series User Guides, however the process is similar to what's mentioned in the guides linked above.

View solution in original post

3 Replies 3

Dennis Mink
VIP Alumni
VIP Alumni

of the top of my head if you go into the sx20 GUI configuration>advanced configuration>video there is an option for dual or single screen

Please remember to rate useful posts, by clicking on the stars below.

Wayne DeNardi
VIP Alumni
VIP Alumni

You cannot create custom layouts, you will have to use one of the in-built layouts as mentioned in [@patrick.sparkman]'s response.

Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.

Wayne
--
Please remember to mark helpful responses and to set your question as answered if appropriate.

Patrick Sparkman
VIP Alumni
VIP Alumni

If the SX20 is setup to use a single output, the far-end video and presentation content will be displayed on the same screen, you have four layout options: Equal, Prominent, Overlay, and Single.  Depending on if you're using a remote control or Touch 10 with the SX20, the layout controls are outlined in the below guides:

SX Series User Guide for Remote Control (CE8.2)
MX and SX Series User Guide for Touch 10 (CE8.2)

If you still happen to be using TC software on your SX20, refer to the other SX Series User Guides, however the process is similar to what's mentioned in the guides linked above.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: