Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1796
Views
5
Helpful
1
Replies

Audit log for TMS? How to determine when/how an endpoint was deleted?

ROGER MCGUIRE
Level 1
Level 1

‎01-07-2013 02:18 PM - edited ‎03-18-2019 12:23 AM

Is there any sort of audit log in TMS that will show when/how/who deleted an endpoint (C-series, EX90, etc) from the TMS system?

Labels:
0 Helpful
1 Reply 1

Magnus Ohm
Cisco Employee
Cisco Employee

‎01-07-2013 11:32 PM

Hi

You can enable the TMS audit log under General Settings. The audit log is not enabled by default.

This is the information you get in the audit log when you delete (purge) a system from TMS.

/Magnus

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents