TelePresence and Video Infrastructure

All,Just wondering if the Telepresence systems can be utilized by other systems.  For example,  Customer A has a Telepresence sytem and Customer B has Some other video conference hardware.  Can this be made to work  and if so, in general how hard wou...

I'm having a problem with a dial peer link between two sites.  The short explanation is that when I dial the dial-peer it rings on the other side, but when the recipient picks up, it's just dead air.  Additionally, the caller does not hear the ringin...

Hi, I have a client reported that when he was using HD.323, he found pkt loss about 8%. The network is consisted of cat6500 and cat3750, all of interface are 1G. The throughput for the application is about 2Mps.IOS version for 6500 is 12.2(33)SXH5.IO...

has anyone been able to register a polycom sip phone on a callmanager express? i especially need help on configuring the polycom phone

All,If i were looking at buying the Telepresence 500 from scratch. what would i need? and more importantly, how much would it cost?

Hey there,I am wanting to host some meetings at my hospital, but i dont want to invest in the Telepresence (we dont have VOIP). Anyway, if I were to create a seperate VLAN and just host the camera on this network, what kind of setup could i use? Any ...

Hi,I have this message on my 2811 / ios:12.4(15)XZ2Feb 18 18:59:41.489: %MGCP-3-INTERNAL_ERROR:  mgcp_cfg_commands: nvgen lawful-intercept: should not happenDo you know how to remove this from my screen?Thanks!

Hi,I have CUCM 7.x and 15 (fifteen) Cisco 7985. Point-to-point video calls are working fine.Now to allow multipoing video calls for internalusers I'm planning to add MCU-3515-12U and 5 (five)9971 Cisco SIP-based IP Phones although CUVA-III USBcameras...

Hello,I'm trying to join two H.323 networks together and I am after some help / advice.One of the networks is managed and the other not and therefore external.Both networks have an IP-IP Gateway running Gatekeeper and CUBE. The Video devices in each...

Hi, Please help me.I have to implement VoIP using MPLS like following.PBX-A---(E1)---Cisco2811---MPLS---Cisco3725---(E&M)---PBX-BI need to configure Cisco2811 and need to ask PBX-A vendor to add E1 card  and configuration to PBX-A.Should I pay attent...

Are there documents availlable describing the Room Remediation Requirements for 3210 and 3010 rooms?

Hi Guys, I have a VoIP environment, SCCP phoneA --- Call Manager --- H323 IP2IP GW ----CME--- SCCP phoneB. When Phone B call Phone A, PhoneA rings and accepts, it shows connected, however PhoneB is still ringing, call can not be established. anyone h...

HiWe have a CUCM and Cisco unified video conferencing setup seperately. We have 7985 Phones registered with CUCM. Pl clarify me how to integrate this Video Phone with the setup of CUVC and take this phone in video conferencing.CUCM version 7.0CUVC 35...

Does anyone have a basic configuration for sending video through a CUBE. We are using MeetingPlace but really the first part is that we need to make Video calls from endpoints on our internal networks to video participants on the Internet. The docu...

Hi,I have 3750 series switches whic h modify the voip cos to cos 5, these act like a layer 2 devices. The switches are connected to ASA 5500 firewall and firewalls to WAN, How can i implement the layer 3 dscp marking on switches or firewalls? if i ap...