TelePresence and Video Infrastructure

Hi Guys,we have Cisco IPT in the compnay and a customer wants to make a video conference using Polycom VSX 7000.is it possible since to make a video call from Polycom VSX 7000 to Cisco IPT or vice versa?please it is little urgent......Thanks in advan...

In comparing calls that are traditionally connected using an endpoint's multisite option versus calls that are connected utilizing a Codian MSE 8000, it is noticeable that shared PC content is much clearer and sharper via the traditional means and su...

Can a VCS control make video calls outside the enterprise via CUBE instead of Expressway?  I know that using Expressway would be better, but we are trying to get something up and running quickly with what we currently have, with a view to purchasing ...

H320 to H323 gatewayI  have to set up a video conference environment with a video endpoint registered how h323 to CUCM. Internal videoCalls run ok.I have problems with PSTN videocalls. I route this videoCalls to a Cisco Gateway 2821 by E1.Cisco 2821 ...

Hello allI have a Communications Manager Express running 8.5 and have been trying to connect it to an ITSP via a SIP trunk (Broadsoft SBC).There is a requirement to use the P-Asserted-Identity field in the INVITE header configured for the pilot numbe...

I have 9971 phone and was dialing sip to sip and sip h323 on the network, but now I get Apr 20 14:17:58.911: %VOICE_IEC-3-GW: Application Framework Core: Internal error (Toll fraud call rejected): IEC=1.1.228.3.31.0 on callID 12 GUID=BCBC7FI

Hi allI have an problem when making a call between  CTS 500 system and CTS 3XXX, The call between these two systems is established Cts 500 to Cts 3xxx audio and video is going properly ,But pblm is the other side (cts 3XXX) not able to make video cal...

Hi all  How to get training in telepresense from cisco any ideas pls post the  details .We have partnersRegards

Hi,Trying to get the CUVC to register to the VCS Control. It will register is H323, but SIP only registers for 1 min before unregistering. The log show the registration timer expired. I do not see anywhere on the CUVC to configure this or on the VCS ...