TelePresence and Video Infrastructure

After finished the installation of CTS1300 that just ship to me.I try to login at Administration Login Screen with user: Admin and password: ciscoBut it's fail to login.Please help to give me the process of password recovery.

HiI am fairly new to wireless and need some clarification about Voice conferencing. We have Cisco call manager now my office want make a voice conferencing with other office .we are looking a conferencing device which should be wireless and getting I...

Hi Guys,I'm struggling to find the Voice Debug commands output explaination guide.I need to understand the debug outputs, which is very diffcult to understand , Can someone help me out to get this.Thanks,Oliver

Do you know of any "Reconfiguration and Upgrade Guides" for CUCM 7.X that explains the process of pointing the Pub and Sub to a new domain? I have searched and so far I have not found anything explaining a step process for this task.Thanks in Advance...

Hi,i have purchased all 4 VOIP Network Management Software (CUOM, CUSM, ecc...) with their PAK. Now i'm going to register the 4 PAK, but i have a doubt: Cisco requires the MAC address of the server that hosts the Management Software. I have installed...

Im just curious if anyone has run across a way        to integrate a "Door Phone" with IP telephony.  I am looking to see if there is any device that we could use that would "pop" a video screen up on the pc when they dialed the phone. In most of our...

CCM 4.1(3)   2851 12.4(25b)User at remote site tries to transfer a call from the PSTN to another site.Call arrives at remote phone, but no audio in either direction. (No re-order or anything, just dead air)Call information appears on destination phon...

I have a Polycom HDX 4000 configued and registered as an Advance SIP device to CUCM 7.0.2 and CUVA and when I place a call between those devices it is connected as Audio Only.Polycom HDX is upgraded to the lates version to support CUCM, CUVA is lates...

Hi All, Could someone confirm how the CTMS handles the speaker switching mode in the below particular scenario.Let's say we have 4 CTS3000 rooms that I will name with each of its segment below: Sunnyvale: SUN1, SUN2, SUN3SanJose: SJ1, SJ2, SJ3Tokyo: ...

Hi All, Im getting echo/feed back on my 3CX phone system, I have narrowed it down to the SPA 3102 boxes, done factory reset, tried 2 different boxes, tried different phones and phone lines, SPA 3102 with factory reset plugged in to BT line/socket wit...

Dear all, I have a question about are there any way to indicate to a calling user who calls a user phone with a busy trigger set to 2 that this called user is on another call ? because by default the called user (who is already on a call) will see an...

Yesterday we had a strange problem with a CTS-3000 unit dialling into a scheduled multipoint call.Prior to the call, the unit wasn't registering any errors, but as soon a the call was started, we recieved alerts via our NMS system for"Main Camera: Li...