TelePresence and Video Infrastructure

Hi,I have AS5350 in the main site and noo cisco voice gateways at the remote site with analog phones, AS5350 is connected to PBX through E1 R2, call is successful between main and remote but not from remote to remote.Attached the configuration of the...

Hi, I have a problem with the Cisco Video Advantage, I have installed the aplication in the computers, and check the aplication, doing click in the Video Check, and I can see the remote and local video windows. The computer is connected to a 7960 Cis...

Hello , We have implemented HSRP configuration between the core switches for 20 VLANs, as the following:HSRP Configuration for switch 1;Interface Vlan4 Description “VLAN Description” Ip address 192.168.8.2 255.255.255.0 Standby 5 ip 192.168.8.1 S...

Our company plans to move out the Cisco TFTP service from CCM to easy the CCM's traffic. Do we have to use Cisco TFTP service for the new TFTP server? If so, do we need to have additional licenses to setup Cisco TFTP service in the new TFTP server?Pl...

I've a video conferencing application on some hosts inside my network which need to connect to a H323 Gatekeeper outside ( internet )The internet connection is made via a 1401 router with IOS 12.2.6 .We tested the configuration with a static nat for ...

We just received two 4305G Digital Media Players. We have no backend server or streaming server or anything like that. We're a fairly small shop so we don't have anyone particularly gifted in HTML.Does anyone know of a place to find some templates or...

I have a few cameras I have not been able to install. When I install unified video advantage software. I then plug the camera in when asked to finish install. I recieve a message that there was a problem with the install of the device and it may not ...

Hello, this weekend our IPCC sever switched over to daylight savings (a week early)I had to switch from Pacific Time(US & Canada)Tijuana time zone to (GMT-07:00)Arzona time zone (this setting in on all of our servers), I made the change clicked apply...

Hi Guys,I am currently trying to configure 2 3825's to act as both gateway and gatekeeper so I can proxy video conferencing between two locations. I have applied what is seemingly the correct configuration to my interface to enable h323 gateway funct...

Is there a way to force a CME (or any IOS GW) to sending outbound PSTN calls to a PRI using overlap sending? I am able to overlap-receive but not overlap-send.I am using a primary-net5 PRI.Thanks.Pavel.

Dear all, We have voIP between two sites, connected over MPLS and voice calls drop now and then. We use Avaya for Voice boxes and Cisco routers/switches elsewhere. QoS is configured on both ends of the MPLS to prioritize voice packets and I do not se...

Hi has anybody intergrated VCM with CM5, as the documentation does not seem to mention this. The CM5 controlled end point will be 7985's and an VT advantage. There is also a 3515 MCU. The MCU registers with the VCM ok. But not sure on the intergratio...

hi mates,Does the NM-HDV2-1T1/E1 module support EuroISDN ( ETS 300) signaling?

I have a voicemail system at my company and any voicemail box that you call gives you a time that is 8 hours off of the correct time. I have gone into the unity configuration page and checked the time zone and everything and it shows the correct time...

I'd like to know what's the best solution/product for video conferencing using CallManager Express (NOT Callmanager).