TelePresence and Video Infrastructure

I am working on prioritizing my voice traffic from one VOIP server to the other. here is the setup:phone---serverA--routerA--fiberlink--rouerB--serverB---ciscogateway----pstnThis is the config from the routerA: ServerAclass-map match-any voip-priori...

Just want to setup a very simple video enviroment in the lab to test 4.13 video feature? I am thinking to use the following devices:1.CCM 4.132. 2 7970(Does this support video?Anything else do I need? I don't think I need MCU stuff for two endpoint v...

Hi I am using 3660 and 3640 router for doing Video over IP. I don't have problem in doing same but I am facing problem in monitoring of the same. I have applied policy map and when I am giving command " Sh policy-map " on 3640 it gives me more detail...

Hi all, this is the situation: one centrale site and one remote site. Each site has a Gatekeeper and several IP Phones. The two sites are connected through a vpn. Five subnets of the remote site must be able connect to two of the networks of the cen...

hi all!can i priority voice traffic in a campus LAN ? we have 2950 EI switch on the access an 3550 on the core layer with vlans...i search a configuration examplemany thanks for the answers!

Hello,I was wondering what would be needed to set up a basic Voice lab for home. I have a lab currently of 1 2610, 12 2500's, 1 4000. A 2950 switch, and a Catalyst 5000 switch.I know I would need atleast two IP Phones, 7960 or 7940's. Would a Cisco 2...

Hi all, We are running into a problem with channel changes on and IPTV network. Each channel is a mulicast address. I have two 6509 switches, each running 12.2(18)SXF3 Switch 1 (S1) has the multicast source located on it. Switch 2 (S2) has our custom...

I am working on getting this out to the rest of our staff but am running into little bugs. I am running 5.2.5 and when some machines connect to program manager succecssfully and try to connect to a channel the video screen pops up but does not displa...

Hello to everybody!Problem Details: We have a series of Cisco 6260 DSLAMs and we consider multicast providing. That is why I have some questions about functionality of this device.1. We know, that DSLAM doesn't support such feature as VC mer...

Hi everybodyI'm working on VoIP CME& as i want to identify the noises on my line during conversations.I read in the current Cisco doc that there are a Cisco Utility to capture RTP stream to be able to send it to the TAC.http://www.cisco.com/en/US/tec...

1760 running 12.4(3a)---------------------I had a client that had a hung FXO port (connected to a paging system). The port was at a "S_OPEN_PEND" status when you viewed it 'show voice call summary'Shutting/No Shutting the Voice-Port did not make a d...

Hi everybody,I'm new in voip.I need to install callmanager on a 2621XM or 26111XM router using a c2600-advsecurityk9-mz.123-14.T7.bin.cme-123-14T5.zip has been uncompressed and copied into the router.I tried to use telephony-service and ephone comman...

I am new to Cisco IP video technology. We are running CCMv4.1(3). Just want to verify if I have no Cisco IP/VC 3511 or 3540 MCU devices, only video end-to-end call can support. Also we have few sccp tandberg devices and would like to try to register ...

How do you enable the 7Mbps wideband codec for VT Advantage? I can't find the configuration setting, but the CIPT 4.1 part 2 class states that you can do this.

I have a remote site running SRST back to a 4.x CallManger and I am trying to figure out what is the best gateway to run MGCP or H323, the router will need dial peers, so that is can dial out when is SRST mode. What is the best gateway type to use